UNIVERGE SV8100 Issue 5.0
Direct Station Selection (DSS) Console 1 - 429
When a multiline terminal user is on a call, they can transfer to another station by pressing
a DSS key for that station. It is not necessary to press Transfer to transfer to another
station using a DSS key.
. When a multiline terminal user is on a call, they must press Transfer to transfer a call off site with a DSS
key.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered
as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ can be entered in the dial string of a DSS/One Touch button. The @ only applies to
ISDN and Intercom calls. When using the @, the system waits for the destination to answer
(answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom
calls, or after the @ for ISDN calls.
Up to 32 different extensions with DSS Consoles can be set up
A single extension can have up to four 60-button DSS Consoles (32 is the maximum
allowed per system).
Only 1 console can be physically attached to an IP terminal, the remaining 3 must be hard
wired from a TDM port.
When fitted to an IP terminal the DSS console requires it’s own power supply. PoE is not
supported for the DSS console.
A ‘Page Switching’ key (code 95) can be assigned to one of keys 55~60 of the console to
reveal a second layer of keys. If assigned this will limit the amount of keys to 59 per page.
Each DSS console fitted to a TDM port will require a TDM port license.
Default Setting
No DSS Consoles assigned (in Program 30-02-01).
All DSS Console key ranges are ports 1~200.
Once a DSS Console is enabled, the console keys are DSS keys (Program 30-03-01).
System Availability
Terminals
All Multiline Terminals
To Next Page
Loading...
