NEC Univerge SV8100 - Page 49

UNIVERGE SV8100 Issue 5.0
Analog Communications Interface (ACI) 1 - 39
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-01 ETU Setup (DLCA PKG Setup) –
Terminal Type (B1)
Assigns or displays the current
terminal type assigned to B
Channel 1 for each port on the
DLCA.
0 = Not set
1 = Multiline Terminal
2 = SLT Adapter
3 = Bluetooth Cordless
Handset
6 = PGD (Paging)
7 = PGD (Tone Ringer)
8 = PGD (Doorbox)
9 = PGD (ACI)
10 = DSS Console
11 = -- Not Used --
(default = 0)
10-03-06 ETU Setup (DLCA PKG Setup) –
Terminal Type (B2)
Assigns or displays the current
terminal type assigned to B
Channel 2 for each port on the
ESI.
0 = Not set
6 = PGD(2)-U10 ADP
(Paging)
7 = PGD(2)-U10 ADP
(Tone Ringer)
8 = PGD(2)-U10 ADP
(Door Box)
9 = PGD(2)-U10 ADP
(ACI)
12 = APR (B2 Mode)
(default = 0)
11-06-01 ACI Extension Numbering Assign extension numbers to ACI
software ports. Select a number
outside of the normal extension
number range.
ACI Ports: 1~96
(default not assigned)
11-08-01 ACI Group Pilot Number Assign pilot numbers to ACI
groups. When a user dials the pilot
number, they reach an available
ACI software port within the group.
ACI Groups 1~16
(default not assigned)
14-09-01 Conversation Recording
Destination for Trunks – ACI
Recording Destination
Extension Number
Use this option to assign the ACI
Call Recording destination per
trunk. The destination can be an
ACI port extension number
(assigned in Program 11-06-01) or
an ACI Department Group pilot
number (assigned in Program
11-08-01). If destinations are
assigned in Program 14-09 and
Program 15-12, the destination in
Program 15-12 is followed.
Extension Number =
Maximum eight digits
(default not assigned)
14-09-02 Conversation Recording
Destination for Trunks – ACI
Automatic Recording for
Incoming Calls
Determine whether or not a trunk
should be automatically recorded
when an incoming call is received.
0 = Off
1 = On
(default = 0)