NEC Univerge SV8100 - Page 504

Issue 5.0 UNIVERGE SV8100
1 - 494 Flash
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-42 Service Code Setup (for Service
Access) – Flash on Trunk Lines
Use to customize the Service
Codes for flash on trunk lines.
SLT
(default = 806)
14-02-03 Analog Trunk Data Setup – Flash
Type
Make sure this item is set for open
loop Flash (0).
0 = Open Loop Flash
1 = Ground
(default = 0)
14-02-04 Analog Trunk Data Setup –
Hooking Type
For each trunk, indicate if Flash is
for Flash (0) or open loop
disconnect (1).
0 = Timed Flash
(Hooking)
1 = Disconnect (Cut)
(default = 0)
14-04-01 Behind PBX Setup For each trunk, indicate if the trunk
is installed behind a PBX.
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
15-03-04 Single Line Telephone Basic
Data Setup – Flashing
Enables/disables Flash for single
line telephones.
0 = No
1 = Yes
(default = 1)
81-10-07 COT Initial Data Setup –
Hookflash Time Selection 1
Set the Flash duration (16~4080
ms) for analog trunk CD-4COTB
circuits in Program 81-10-07.
0 = 20 ms
1 = 40 ms
2 = 60 ms
3 = 80 ms
4 = 100 ms
5 = 140 ms
6 = 160 ms
7 = 200 ms
8 = 400 ms
9 = 600 ms
10 = 800 ms
11 = 1.0 seconds
12 = 1.5 seconds
13 = 2.0 seconds
14 = 3.0 seconds
15 = 5.0 seconds
[default = 9 (600ms)]