Issue 5.0 UNIVERGE SV8100
1 - 502 Flexible System Numbering
Conditions
Programming follows a telephone extension number, not the port number in most cases. If
you relocate a telephone, you may need to change additional programming. For example,
if you change the extension assigned to a port in Program 11-02, the line key programming
does not follow. However, if you move the extension using the Station Relocation Feature,
the line key programming does follow.
Since making changes in Program 11-01 does not automatically make any other changes in
any other program, changing the number plan after the system is in operation may cause
problems in the following programs:
Any feature which requires dialing a code or extension number can be affected.
When the system searches the Dial Extension Analyze Table (PRG 11-20-01), the system
uses prefix searching, giving the lower table number the higher priority. For example, the
user programs 211 in table 1 and 2113 in table 2, then dials 2113, the system selects table
1.
11-10 Service Code Setup (for System Administrator)
11-11 Service Code Setup (for Setup/Entry
Operation)
11-12 Service Code Setup (for Service Access)
11-13 Service Code Setup (for ACD)
11-14 Service Code Setup (for Hotel)
11-15 Service Code Setup, Administrative (for
Special Access)
Customize the Service Codes.
11-16 Single Digit Service Code Setup Assign the Single Digit Service Codes. these are the
post-dialing codes a user can dial after placing an
Intercom call to a co-worker.
PRG 11-01 Type 2
(Extension Number)
PRG 11-01 Type 1
(Service Codes)
11-02 11-08 15-12 22-11 11-10 11-14 21-11
11-04 11-17 16-01-01 25-06 11-11 11-15 30-03
11-06 15-01-01 15-14 30-03 11-12 15-07
11-07 15-07 21-11 11-13 15-14
Flexible System Numbering (Continued)
Program Description
To Next Page
Loading...
