Issue 5.0 UNIVERGE SV8100
1 - 534 Flexible Transfer/Virtual Loopback
o Easy Edit reference
o Blade Configuration, Virtual Loopbacks, Virtual Loopback -Extension Port.
4. Give the department group a pilot number (e.g. 5 - re-configuration of system numbering will be
required for this.)
o Easy Edit references
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Department group
o Blade Configuration, Virtual Loopbacks, Numbering Plan.
5. Allocate additional digits required e.g. 2
o Easy Edit reference
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Basic Setup, S-Point DDI Digits.
6. Place virtual loopback trunk ports into a trunk group
o Easy Edit reference
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback Trunk Group
7. Configure DDI routing for trunk group and virtuals ddi's in this example 500 - 599
o Easy Edit References
o Cards, Virtual Loopback Setup, Virtual Loopback Routing, Virtual loopback DDI Table Area Setup
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback DDI Table Area
Target,
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback Trunk Type
o Blade Configuration, Virtual Loopbacks, Virtual Loopback Routing, Virtual Loopback DDI Routing Table.
8. To configure, for example 500 to IRG 1 enter receive digits as 500 in a DDI table and enter target 2
with IRG 1.
It should now be possible to dial 500 internally and ring IRG 1.
The same scenario could be used for dialling across System Feature Networking.
To Next Page
Loading...
