NEC Univerge SV8100 - Page 561

UNIVERGE SV8100 Issue 5.0
Handsfree and Monitor 1 - 551
Prime Line Selection
Guide to Feature Programming
Operation
To talk Handsfree:
1. Press Speaker, Trunk Line key or Virtual Extension key.
2. Place the call.
3. Speak toward the telephone when the called party answers.
Program
Number
Program Name Description/Comments Assigned Data
15-02-08 Multiline Telephone Basic Data
Setup – Automatic Handsfree
Use this option to set whether
pressing a key accesses a
One-Touch Key (1) or if it
preselects the key (0).
0 = Preselect
1 = One-Touch
(Automatic Handsfree)
(default = 1)
15-02-16 Multiline Telephone Basic Data
Setup – Handsfree Operation
Enable (1) or disable (0) ability of
an extension to use the
speakerphone on outside calls.
When disabled, users can hear
the conversion, but cannot
respond handsfree.
0 = Disable
1 = Enable
(default = 1)
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Use this option to enable (1) or
disable (0) Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
20-06-01 Class of Service for Extensions Assign Class of Service (1~15) for
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension
ports = Class 1
20-09-05 Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Turn off or on an extension ability
to enable Handsfree Answerback
or Forced Intercom Ringing for
their incoming Intercom calls.
0 = Off
1 = On
(default = 1 for COS
1~15)