NEC Univerge SV8100 - Page 567

UNIVERGE SV8100 Issue 5.0
Handsfree Answerback/Forced Intercom Ringing 1 - 557
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-11-15 System Numbering – Enable
Handsfree Incoming Intercom
Calls
If required, change the service
code used for setting an extension
to voice announce for incoming
ICM calls.
MLT
(default = 821)
11-11-16 System Numbering – Force
Ringing of Incoming Intercom
Calls
If required, change the service
code used for setting an extension
to forced ringing for incoming ICM
calls.
MLT
(default = 823)
11-12-06 Service Code Setup (for Service
Access) – Switching of Voice
Call and Signal Call
If required, change the service
code used for toggling an outgoing
ICM call between a voice call and
signal call.
MLT, SLT
(default = 812)
15-02-16 Multiline Telephone Basic Data
Setup – Handsfree Operation
Enable (1) or disable (0) ability of
an extension to use the
speakerphone on outside calls.
When disabled, users can hear
the conversion, but cannot
respond handsfree.
0 = Disable
1 = Enable
(default = 1)
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Use this option to enable (1) or
disable (0) Forced Intercom
Ringing. If enabled, incoming
Intercom calls normally ring. If
disabled, Intercom calls
voice-announce.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
20-06-01
Class of Service for Extensions
Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension
ports = Class 1
20-08-10
Class of Service Options
(Outgoing Call Service) – Signal/
Voice Call
In an extension Class of Service,
enable (1) or disable (0) an
extension ability to toggle between
Handsfree Answerback and
Forced Intercom Ringing for
outgoing Intercom calls (dial 1 or
Service Code 812).
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-09-05
Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Turn off or on an extension ability
to enable Handsfree Answerback
or Forced Intercom Ringing for
their incoming Intercom calls.
0 = Off
1 = On
(default = 1 for
COS 1~15)