NEC Univerge SV8100 - Page 62

Issue 5.0 UNIVERGE SV8100
1 - 52 Answer Key
Guide to Feature Programming
Operation
Program
Number
Program Name Description/Comments Assigned Data
22-02-01 Incoming Call Trunk Setup Assign the incoming trunk type for
each trunk.
Incoming Type for Day/
Night Mode (1~8):
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-04-01 Incoming Extension Ring Group
Assignment
Assign extensions to Ring Groups.
Use this program to assign
extensions (up to 32) to Ring
Groups. Calls ring extensions
according to Ring Group
programming. There are 100
available ring groups.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
22-05-01 Incoming Trunk Ring Group
Assignment
Assign trunks to incoming Ring
Groups. Use this program to
assign Normal Ring Trunks
(Program 22-02) to Incoming Ring
Groups (Program 22-04).
Incoming Group
Number for Day/Night
Mode (1~8):
0 (No Setting)
001~100
(Incoming Group)
102 (In-Skin/ External
Voice Mail or InMail)
(default = 1)
22-07-01 DIL Assignment Assign the destination extension
or Department Group Pilot
Number for each DIL Incoming
trunk.
Number of Transferring
Destinations for Day/
Night Modes (1~8):
Extension Number
(maximum eight digits)
Pilot Number
(default not assigned)