NEC Univerge SV8100 - Page 675

UNIVERGE SV8100 Issue 5.0
Meet Me Paging Transfer 1 - 665
. For additional programming information on Paging, refer to the Paging, External and Paging, Internal features.
15-07-01 Programmable Function Keys Assign function keys for External
Zone Paging (code 19 + zone),
External All Call Paging (code 20),
Internal Zone Paging (code 21 +
zone) or Meet Me Conference/
Paging Pickup (code 23).
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-10-06 Class of Service Options
(Answer Service) – Meet-Me
Conference and Paging
Turns Off (0) or On (1) an
extension to use Meet-Me
Conference and Paging.
0 = Off
1 = On
(default = 1 for
COS 1~15)
31-02-01 Internal Paging Group
Assignment – Internal Paging
Group Number
Assign extensions to Internal
Paging Groups (i.e., Page Zones).
0~64
(0 = No Setting)
Default:
0 for IP Station
1 for TDM Station
31-02-02 Internal Paging Group
Assignment – Internal All Call
Paging Receiving
Allow or prevent All Call Internal
Paging for each extension. If
allowed, extension can place and
receive All Call Internal Paging
announcements. If prevented,
extensions can only make (not
receive) All Call Internal Paging
announcements. If combined,
Paging zones should be restricted
as well, change the internal page
zone group in Program 31-07-01
to 0.
0 = Off
1 = On
(default = 0)
31-03-01 Internal Paging Group Settings –
Internal Paging Group Name
Assign name to Internal Paging
Groups (i.e., Page Zones). The
system shows the name you
program on the telephone display.
Up to 12 characters
Refer to table in
Programming Manual.
Program
Number
Program Name Description/Comments Assigned Data