NEC Univerge SV8100 - Page 689

UNIVERGE SV8100 Issue 5.0
Message Waiting 1 - 679
To answer a Message Waiting:
.
When you have a message, your Message Waiting LED flashes fast for multiline terminals.
1. At the multiline terminal, press Speaker and dial 841.
- OR -
Press the Message Waiting key (Program 15-07 or SC 851: 38).
- OR -
At the single line telephone, lift the handset and dial 841.
. If the called extension does not answer, dial 0 or press your Message Waiting key to automatically leave them a
message.
. Normally, your Message Waiting LED goes out. If it continues to flash, you have new messages in your Voice
Mail mailbox or a new General Message. See “To check your messages” below.
To cancel all your Messages Waiting:
.
This includes messages you have left for other extensions and messages other extension have left for you.
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 873.
3. Hang up.
To cancel the Messages Waiting you have left at a specific extension:
1. At the multiline terminal, press Speaker.
- OR -
At the single line telephone, lift the handset.
2. Dial 871.
3. Dial the number of the extension you do not want to have your messages.
4. Hang up.