NEC Univerge SV8100 - Page 756

Issue 5.0 UNIVERGE SV8100
1 - 746 Operator
Related Features
Attendant Call Queuing
Guide to Feature Programming
Operation
Refer to the individual features for operation.
Program
Number
Program Name Description/Comments Assigned Data
20-01-01 System Options – Operator
Access Mode
Use this program to set up priority
of a call when calling an operator
telephone (0 = Step, 1 = Circular).
0 = Step
1 = Circular
(default = 0)
20-17-01 Operator Extension – Operator’s
Extension Number
Designate an extension an
operator. When an extension user
dials 0 or 9 (defined by Program
11-01, Type 5), calls go to the
operator selected in this program.
If you do not assign an extension
in Program 90-11-01, system
alarms appear on the extension
assigned in this option.
Up to eight digits
(default not assigned)
20-35-01 Extension’s Operator Setting Assign an extension to an
operator group.
(Input: 0~15)
20-36-01 Trunk’s Operator Setting Allows the user to select Operator
Group per trunk.
(Input: 0~15)
(0 = Not assigned)
(default = 0)
20-37-01 Operator Extension Group Setup Define the initial operator
extension in the operator group.
Up to eight Digits
(default not assigned)
20-38-01 Operator Group Setting Use this program to set up priority
of a call when calling an operator
telephone.
0 = Step
1 = Circular
(default = 0)