NEC Univerge SV8100 - Page 758

Issue 5.0 UNIVERGE SV8100
1 - 748 (OPX) Off-Premise Extension
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-01 ETU Setup Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
10-09-01 DTMF and Dial Tone Circuit
Setup
Allocate the circuits on the
CD-CP00 ETUs for either DTMF
receiving or dial tone detection.
Program 14-01-13 Basic Trunk
Data Setup – Loop Supervision
Enable (1) loop supervision for
each trunk that should be able to
use Call Forwarding – Centrex.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
15-03-01 Single Line Telephone Basic
Data Setup – SLT Signaling Type
For each UNIVERGE SV8100
voice mail extension, this option
must be set to 0.
0 = DP
1 = DTMF
(default = 1)
15-03-03
Single Line Telephone Basic Data
Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always
enter 1 (e.g., receive DTMF
tones).
0 = Normal
1 = Special
(default = 0)
15-03-05 Single Line Telephone Basic
Data Setup – Trunk Polarity
Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0 = Off
1 = On
(default = 0)
15-03-06 Single Line Telephone Basic
Data Setup – Extension Polarity
Reverse
Do Not Change Default Entry as
DTMF issues may arise with voice
mail.
0 = Disable (Off)
1 = Enable (On)
(default = 0)
15-03-07 Single Line Telephone Basic
Data Setup – Enabled On-Hook
When Holding (SLT)
Used to enable or disable Enabled
On-Hook When Holding for SLT.
0 = No
1 = Yes
(default = 1)