NEC Univerge SV8100 - Page 794

Issue 5.0 UNIVERGE SV8100
1 - 784 Park
instead.
If the co-worker does not answer th ecall, it will recall to the originator’s extension.
To pick up a call parked at your extension:
1. Press the Personal Park key (Program 15-07 or SC 852: *07).
- OR -
Press Speaker and dial 773.
At a single line telephone, skip pressing Speaker.
The Personal Park single-digit service code (Program 11-16-11) cannot be used in this operation.
If it recalls the extension, pressing the Personal Park key or flashing Speaker answers the call.
To answer a call parked at a co-worker’s extension:
1. Press Speaker, dial 715 plus the co-worker’s extension number.
At a single line telephone, skip pressing Speaker.
To display Caller ID for a call in Park:
.
With Program 15-02-08 set to 0 (preselect) for this feature.
1. With Program 15-02-08 set to 0 (preselect) and a call in Park, press the Park key. (Program 15-07
or SC 852: *04).
- OR -
With Program 15-02-08 set to 1 (One-Touch), and a call in Park, press Feature, then the Park key
(Program 15-07 or SC 852: *04).
Call Park – Step Call:
To Park a call in the first available system orbit:
.
You can Park Intercom or trunk calls.
1. Press Hold or Transfer.
2. Dial 831.
If you hear a busy tone, the orbit is busy. Proceed to step 3.
3. Dial *.
Program 20-11-27 must be enabled in the Multiline Terminals Class of Service.
4. Press Speaker to hang up.
If not picked up, the call will recall to you.
- OR -
1. Press Hold or Transfer.
2. Press the DSS/BLF key programmed as 831(The Park location will be displayed in the LCD).