NEC Univerge SV8100 - Page 809

UNIVERGE SV8100 Issue 5.0
Private Line 1 - 799
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
14-01-09 Basic Trunk Data Setup – Private
Line
Determine if a trunk should be
used as a normal (0) or private (1)
line.
A Private Line reserves a
trunk for a multiline terminal
for placing and answering
calls. A user with a Private
Line always knows when
important calls are for them.
Additionally, the user has
their own trunk for placing
calls that is not available to
others in the system.
0 = Disable Private
Line (Normal)
1 = Enable Private Line
(Private Line)
(default = 0)
14-07-01 Trunk Access Map Setup – Trunk
Port Number
Assign Private Line to the Private
Line Access Map (refer to
Program 15-06 in this section).
Use option 5 for Incoming, option
7 for Both Ways and option 4 for
Outgoing. In all other Access
Maps, assign option 3 to the
Private Line.
0 = No access
1 = Outgoing access
only
2 = Incoming access
only
3 = Access only when
trunk on Hold
4 = Outgoing access
and access when trunk
on Hold
5 = Incoming access
and access when trunk
on Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk
on Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is
on Hold).
15-06-01 Trunk Access Map for
Extensions
Assign extension to have Private
Line to an unused Private Line
Access Map.
Trunks 1~200
(default = 1)