Issue 5.0 UNIVERGE SV8100
1 - 804 Programmable Function Keys
One-Touch keys programmed for Park Hold Service Code cannot be used to park calls
without using Hold or Transfer.
Pauses can be entered in the dial string of a DSS/One Touch button. The pause is entered
as P in the dial string and causes the system to wait three seconds before sending the rest
of the digits that follow the P (pause). Multiple pauses can be entered.
The @ can be entered in the dial string of a DSS/One Touch button. The @ only applies to
ISDN and Intercom calls. When using the @, the system waits for the destination to answer
(answer supervision), and then sends the rest of the digits.
Entering a P (pause) in a DSS/One Touch dial string can be used for CO calls, Intercom
calls, or after the @ for ISDN calls.
DSS/One-Touch keys can be used for one-touch transfer.
DSS keys can distinguish whether the telephone is set for DND/Call Forward All Calls of if
the telephone is off-hook.
When a Ring Group call rings a station, a BLF Indication for this station shows idle or busy
based on Class of Service option (20-13-49).
All features programmed under one touch keys are still subject to class of service
restrictions.
If you change the extension assigned to a port in Program 11-02, the line key programming
does not follow. However, if you move the extension using the Station Relocation Feature,
the line key programming does follow.
In order for a station to retrieve a held ICM call, the station must have an ICM key assigned
in 15-07 (*00).
The following function key codes are not supported on the Bluetooth handset: 03, 04, 05,
10, 11, 12, 13, 14, 15, 16, 17, 18, 30, 31, 33, 39, 47, 48, 50, 53, 54, 55, 66, 80, 82, 85, *10,
*14, *30, *31.
Default Setting
The first eight keys on a telephone are line keys (e.g., key 1 = line 001). The remaining keys are
unassigned.
12 Call Forward – No Answer CFNA
13 Call Forward – Busy/No Answer CFBNA
14 Call Forward – Both Ring CFBOTH
15 Follow Me FLWME
. If a key is programmed as a DSS/One-Touch key for a station that is set for Call Forward All Calls or Do
Not Disturb, the DSS/One-Touch key flashes.
. Refer to the UNIVERGE SV8100 Programming Manual for a complete list of Function Numbers.
Function
Number
Function Display
To Next Page
Loading...
