NEC Univerge SV8100 - Page 824

Issue 5.0 UNIVERGE SV8100
1 - 814 Q-Sig
Related Features
Direct Inward Dialling (DID) / Direct Dial In (DDI).
Central Office Calls- Answering
F-route
Department Groups
ISDN Compatibility
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-01
ISDN Line Mode
Defines the setting of the PRI or
BRI for trunk or S0 connections.
0 = Not set
1 = T-point
2 = S-point
3 = NW Mode (Leased
Line)
4 = NW Mode
(Interconnected line)
5 = NW Mode
(Interconnected line -
ficed layer 1 = NT)
6 = S-point (leased
line)
10-03-07
S-point DDI digits
Defines the amount of additional
DDI digits to be sent when set as
S-Point
0~4
(0 = default)
10-03-22
Q-Sig Mode
Defines whether the ISDN circuit is
to be configured for QSig
connection
Disabled (not checked)
Enabled (checked)
Default not assigned
11-07-01
Department Group Pilot Numbers
– Dial
Use to assign pilot numbers to
each Department Group set up.
Up to eight digits
(default not assigned)
16-01-01 Department Group Basic Data
Setup – Department Name
Assign a name to the Extension
(Department) Groups.
Maximum 12
characters
(default not assigned)