NEC Univerge SV8100 - Page 853

UNIVERGE SV8100 Issue 5.0
Ringdown Extension (Hotline), Internal/External 1 - 843
Guide to Feature Programming
Operation
To place a call if your extension has ringdown programmed:
1. Lift the handset.
Program
Number
Program Name Description/Comments Assigned Data
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-08-01 Class of Service Options
(Outgoing Call Service) –
Intercom Calls
Turns Off or On Intercom calling
for the extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-08-09 Hotline Turns Off or On Hotline feature for
th eextension
0 = Off
1 = On
(default = 0 for
COS 1~15)
21-01-09 System Options for Outgoing
Calls – Ringdown Extension
Timer (Hotline Start)
After the user lifts the handset, the
extension automatically calls the
ringdown destination after this
interval (0~64800 seconds). A
setting of 0 immediately rings the
programmed extension. Any other
setting delays the ringdown the
number of seconds programmed.
0~64800 seconds
(default = 5 seconds)
21-11-01 Extension Ringdown (Hotline)
Assignment
Program the ringdown (Hotline)
source and destination (target)
number, up to 24 digits (512
Hotline assignments). Remember
to include the trunk access code
(usually 9) in front of the number
when dialing outside numbers.
When programming Speed Dial –
System numbers as the
destination, the entry should be
853 + bin number (the service
code for Speed Dialing and the
Speed Dial bin number).
0, *, #, Pause, Hook
Flash,
@ (Code to wait for
answer supervision)
(maximum 24 digits)
(default not assigned)