NEC Univerge SV8100 - Page 974

Issue 5.0 UNIVERGE SV8100
1 - 964 Synchronous Ringing
Guide to Feature Programming
Operation
None
Program
Number
Program Name Description/Comments Assigned Data
14-02-17 Analog Trunk Data Setup – Sync.
Ringing
Enable or disable per trunk. 0 = Disable
1 = Enable (default)
20-15-01 Ring Cycle Setup – Normal
Incoming Call on Trunk
Used to define the ring cycle for
Normal Incoming trunk calls.
Ringing Cycle = 1~13
(default = 8)
20-15-02 Ring Cycle Setup – PBX, CES
Incoming Call
Used to define the ring cycle for
PBX and CES incoming trunk
calls.
Ringing Cycle = 1~13
(default = 8)
20-15-04 Ring Cycle Setup – DID/DISA/
VRS
Used to define the ring cycle for
DID/DISA/VRS incoming calls.
Ringing Cycle = 1~13
(default = 8)
20-15-05 Ring Cycle Setup – DID/DDI Used to define the ring cycle for
DID/DDI incoming calls.
Ringing Cycle = 1~13
(default = 8)
20-15-06 Ring Cycle Setup – Dial-In in the
E&M Tie Line
Used to define the ring cycle for
Dial IN and E&M Tie line calls.
Ringing Cycle = 1~13
(default = 12)
20-15-07 Ring Cycle Setup – Door Box
Ringing for SLT
Used to define the ringing cycle for
Door Box Ringing for SLT
terminals.
Ringing Cycle = 1~13
(default = 8)
20-15-08 Ring Cycle Setup – Virtual
Extension Ring
Used to define the ringing cycle for
Virtual Extensions.
Ringing Cycle = 1~13
(default = 8)
20-15-09 Ring Cycle Setup – Callback Used to define the ringing cycle for
callbacks.
Ringing Cycle = 1~13
(default = 11)
20-15-10 Ring Cycle Setup – Alarm for
SLT
Used to define the ring cycle for
Alarm for SLT terminals.
Ringing Cycle = 1~13
(default = 5)
20-15-11 Ring Cycle Setup – VRS Waiting
Message Incoming
Call
Used to define the ring cycle for
incoming VRS Waiting messages.
Ringing Cycle = 1~13
(default = 6)
22-03-01 Trunk Ring Tone Range – Ring
Tone Pattern
Assign Ring Tone Ranges to
trunks. Trunks ring extensions
according to the Ring Tone Range
selected in Program 22-03-0 and
the settings made with either
Service Code 820 or Program
15-02-02.
0~8
(Ring Tone Pattern
1~4)
(Melody 1~ Melody 5)
(default = 0)