NEC Univerge SV9100 - Page 88

76
Issue 1.0
UNIVERGE SV9100
System Maintenance Manual
Alarm
No.
Type
Name
Content of Alarm
Cause
Action
Recovery
61
Not set
SIP extension
trouble
information.
It failed in the
registration of the SIP
extension terminal.
The SIP extension
terminal was not able to
acquire DSP.
• At Regist to SV9100 of
the SIP extension
terminal.
• When you cannot
acquire the DSP
resource when it sends
it.
• The registered port is used
by other extension.
• The license is insufficient.
• DSP of VoIPDB was not
able to be acquired.
Reconfirm wiring and
the system data
setting.
Confirm whether each
equipment such as
access points works
normally.
62
Not set
DtermIP trouble
information.
The error occurred by
the DtermIP relation.
• When the error occurs
while communicating
with VoIPU or DtermIP.
• When it becomes
impossible to do the
communication
between SV9100 and
DtermIP
• When failing in the
acquisition of DSP.
• The packet loss occurred
on the network or the wiring
cutting occurred.
• DSP of VoIP was not able
to be acquired.
Confirm whether each
equipment such as
wirings and HUB is
normal.
63
Not set
SIP-MLT trouble
information.
The trouble occurred by
the SIP-MLT relation.
• The DSP resource was
not able to be acquired
at incoming/outgoing.
• The negotiation with
VoIPDB failed.
• The packet loss occurred
on the network or the wiring
cutting occurred.
• DSP of VoIP was not able
to be acquired.
Confirm whether each
equipment such as
wirings and HUB is
normal.
64
Major
VoIPDB LAN Link
Error.
The link of LAN of
VoIPDB came off.
• LAN cable is defective.
• Connected HUB broke.
• Defect in CD-CP00.
Confirm LAN
connector and wiring.
Please inquire an
uncertain point of the
maker.
When the
connection returns
normally, the error
is recovered.