To Next Page

To Previous Page

2 - 4 Multimedia Conference Bridge Application

___________________________________________________________________________________

Issue 1.0 UX5000

2.2 Connectors

 Ethernet Connector

The Multimedia Conference Bridge Application has a single 10/100 MPS

Ethernet connector. The port has Auto-MDIX (Auto-Medium Dependent

Interface Crossover) giving users the ability use either a straight-through

Ethernet cable or a crossover Ethernet cable. A crossover cable is not

required for direct connection to a PC.

The Ethernet Interface setting allows for manual configuration of the

Ethernet port mode/speed from the Web Interface. This can be set to

operate in the following port speed and duplex mode: 10MB/Full Duplex,

10MB/Half Duplex, 100MB/Half Duplex, 100MB Full Duplex,

Auto-Negotiate.

 Serial Connector

A 10-pin header (J2) provides access to a serial terminal on the

Multimedia Conference Bridge Application blade. The serial connector

is used for debug operations only.

2.3 Environmental Conditions

The following environmental conditions apply for the operation:

Operating Temperature: +32

° to 104° F (0° to 40° C)

Operating Humidity: 10% to 90% (non-condensing)

NEC UX5000 Installation Manual

Other manuals for NEC UX5000