UX5000 Issue 1.0
Multimedia Conference Bridge Installation Manual 5 - 29
___________________________________________________________________________________
___________________________________________________________________________________
6.1.5 Log Settings (Debug Levels)
6.1.5.1 Set Log Levels
The Set Log Levels window allows the installer to configure
how much information should be sent to the debug log.
This window is used for analyzing any communication errors,
and is intended for use by technical support personnel.
There are three components of the conference bridge for which
the log levels can be set. These include:
❍ Interface Log Level
❍ Application Log Level
❍ Engine Log Level
✎ The maximum size of the rotation log is 1 MB.
The three components can be set to one of the following log
levels. Log messages are categorized from highest level to
lowest as listed below:
❍ None = no messages are logged.
❍ Error = all error messages are logged.
❍ Warning = all warning and error messages are logged.
❍ Information = all information, warning and error messages
are logged.
❍ Debug = all levels of messages are logged when ‘debug’
level is set .
Figure 5-21 Set Log Levels Window
To Next Page
Loading...
