UX5000 Issue 1.0
Multimedia Conference Bridge Installation Manual 3 - 3
___________________________________________________________________________________
___________________________________________________________________________________
6. Port 33 (Extension 333) is the first port assigned to the PVAU.
7. Dial extension 333 to verify the PVAU blade.
8. Steps 1~7 are completed for verification of the blade. Additional
programs are provided to configure the hunt group:
Program 11-07: Department Group Pilot Numbers
Use this data to designate a pilot number for the multimedia CNF
ports.
Program 16-01-04: Hunting Mode
Use this option to set the action taken when a call reaches the last
extension in the department group.
Example: 1=Circular Hunt
Program 16-02-01: Department Group Assignment for
Extension
Use this option to designate an extension to a specific department
group number.
Example: TEL 333
Extension Grp 5
Program 15-03-03: Single Line Telephone Basic Data Setup
Enter option 1 to allow CNF ports to receive DMTF tones after the
initial call setup.
Example: TEL 333
Terminal Type 1: Special
Program 10-55-01: Blade Network Setup
Enter the IP Address for the Conference Applications. Changing
this program requires the UX5000 be reset.
Example:
10-55-01 IP Address XXX.XXX.XXX.XXX
10-55-04 Subnet-M 255.255.0.0
10-55-05 Gateway XXX.XXX.XXX.XXX
To Next Page
Loading...
Need help?
General