NEC Xen Topaz - Installing the EXIFU PCB

Xen Topaz System Hardware Manual
Installing the Optional Equipment - 45
Doc. No. 8846 - Release 1.1 September 2004
1.4 Installing the EXIFU PCB
1. Open and pull out the Sub-Cover.
2. Loosen two screws and remove the Main-Cover.
3. Insert the EXIFU PCB to the EXIFU Slot.
4. When installing the EXIFU-A1, use a blunt object to remove the
plastic filler piece for EXP and Ethernet Connectors.