NEC Xen Topaz - System Shutdown; Powering off the System; Resetting the System

Xen Topaz System Hardware Manual
System Start Up - 75
Doc. No. 8846 - Release 1.1 September 2004
S ECTION 3
SYSTEM SHUTDOWN
3.1 Powering OFF the System
1. The AC Power Switch which is located at the left hand side of each
KSU is OFF.
3.2 Resetting the System
The System is reset by switching the KSU power switch OFF then ON
again.
• The KSU must have its own Commercial AC Power Socket.
• DO NOT POWER ON until all installations have been completed.
• The power switch of the 924M KSU switches the DC power of the
PSU, it does not isolate mains power from the PSU. Always switch
off the mains power from the mains outlet prior to servicing the
unit.
• Before resetting the system, make sure the SW1 switch is set to
"HOT".