September 2004 NEC Business Solutions Ltd
80 - Maintenance
Doc. No. 8846 - Release 1.1
September 2004
2.4 Upgrading the Main Software
1. During the system power ON, open the Sub-Cover and make sure
the SW1 is set to "HOT"
2. Power OFF the system.
3. Loosen two screws and remove the Main-Cover.
4. Insert CF card into the CF Slot on EXIFU-A1. (The EXIFU-A1
should be temporarily installed if the system does not have it.)
To Next Page
Loading...
