NEC Xen Topaz - Unpacking (DSPDB-A1); Switches and Connector Locations; Installing the DSPDB-A1 PCB

September 2004 NEC Business Solutions Ltd
56 - Installing the Optional Equipment
Doc. No. 8846 - Release 1.1 September 2004
3.2 Unpacking (DSPDB-A1)
Unpack the DSPDB-A1 and check it against the following list. Inspect
for physical damage.
3.3 Switches and Connector Locations
3.4 Installing the DSPDB-A1 PCB
1. Open and pull out the Sub-Cover.
2. Loosen two screws and remove the Main-Cover.
Items List of Contents QTY
DSPDB-A1 DSPDB-A1 PCB 1
Nylon Spacers 4
CF (Compact Flash) Card 1 (mounted)
• Make sure the Nylon-Spacers are inserted in each corner of the DSPDB-A1
PCB.
• The spacers must be attached from the back of the DSPDB-A1 PCB so
when installed, the CF slot is facing up.