September 2004 NEC Business Solutions Ltd
74 - System Start Up
Doc. No. 8846 - Release 1.1
September 2004
2.4 Load the Customer Data
The backed up customer data can be loaded to the system by CF
Card. If the it is necessary, EXIFU-A1 PCB must be installed to the
system.
1. Insert the Customer Data CF card to the CF Slot on EXIFU-A1
2. Enter Program Mode (PRG90-04).
3. Dial and press HOLD.
4. When the data backup to the CF Card is complete, the display will
change to the next PRG.
5. Remove the CF Card and exit Programming Mode.
For the details of EXIFU-A1 installation, refer to the Section 5. (Page 5-4)
To Next Page
Loading...
