September 2004 NEC Business Solutions Ltd
70 - System Start Up
Doc. No. 8846 - Release 1.1
September 2004
3. Wait about 2 minutes. The connected Key Telephone's display will
show the Time & Date and Extension Number when the boot
sequence completes.
4. In case of a "COLD Start", change the SW1 position from "OFF" to
"ON" side.
• The default setting of extension number and name is as below.
For the details of numbering, refer to the Programming Manual (separate publication).
The system will automatically assign the extension number and
name to each hardware port, even if the extension is not
connected.
Physical Port No.
Extension
Number
Extension Name
1 200 EXT 200
2 201 EXT 201
:::
To Next Page
Loading...
