NEC Xen Topaz - Page 93

Xen Topaz System Hardware Manual
Specifications Chapter 11 - 85
Doc. No. 8846 - Release 1.1 September 2004
Electrical Specifications
Input Voltage 85VAC ~ 264VAC
Frequency 50 / 60Hz
Power Requirement 1.8A @ 100VAC
(180VA)
0.9A @ 240VAC
(216VA)
Power Consumption 120W
Phase and Wire Single, 2-Wire
Grounding
Requirement
No.14 AWG copper wire
Output Voltage Type +3.42VDC +5VDC -28VDC -27VDC
(Backup
BATT)
Load Fluctuation ±5% ±5% ±5% ±5%
Output Current 0.5A~3.0A 0.0A~2.0A 0.0A~2.0A 0.0A~2.0A
Ripple/Noise 100mVp-p 100mVp-p 200mVp-p 200mVp-p
Over Voltage
Protection
3.7V~6.5A 5.6V~13.0V -32.3V~
-38.2V
-32.3V~
-38.2V
Over Current
Protection
5.5A~6.5A 1.8A~2.1A 4.7A~5.6A 0.22A
Mechanical Specifications
Equipment Width (mm) Depth (mm) Height (mm) Weight (Kg)
924 KSU
360 90 275
2.8
Fully Equipped
OPBOX
130 86 279
1.1
Fully Equipped
Backup Battery Box
384 99 182
5.2
Fully Equipped
Display Type TEL
178 178
84 (Low)
115 (High)
0.829 (12TXD)
0.822 (6TXD)
Standard Type TEL
178 178
84 (Low)
115 (High)
0.819(12TD)
0.812(6TD)
DSS Console 315.5 177 59 0.196
DLS Console 212 60 59 0.196
Doorphone DP-D-1D 98.4 25.4 130.1 0.2