P 268 rev. 1.0 07-2006Technician Menu
2. Set parameters
2.1.2 Coin mechanism
2.1.2.1 Coin mech. set.
2.1.2 Coin mechanisms
2.1.2.1 Setting the coin mechanisms
It is possible to decide which of the payment system protocols
available are to be enabled for the functions.
The available payment systems are:
- Executive
- Validators
- BDV
- MDB
By selecting one of the systems it is possible to control its
functions.
Executive
The following payments systems are available for the Executive
system:
- Standard
- Price Holding
- Coges
- U-Key
- Sida
Validators
When the “Validat. Lines” (line setting) function of the “Techni-
cian” menu is displayed, the value of the 6 validator coin lines
can be changed.
BDV
The BDV protocol menus are used for defining the following
functions:
Type of vending
Setting the operating mode for multiple or single dispensing.
With multiple dispensing, the change is not automatically
returned after a successful selection; however the credit is
available for further selections. When pressing the coin return
button, the available credit is returned if its value is lower than
the maximum change value.
Credit control
This function enables/disables the return of credit if no
selections are made.
If enabled, this function allows the return of coins even if the
first selection was not dispensed.
If however a selection fails for any reason, the change will be
returned if requested.
Maximum credit
This function is used to define the maximum accepted credit.
Maximum change
It is possible to set a limit to the total amount of change
returned by the coin mechanism when pressing the coin
return button or after a single dispensing serving.
Any credit exceeding the amount programmed with this
function will be cashed.
Executive
Validators
BDV
To Next Page
Loading...
Need help?
General
