P 268 rev. 1.0 07-2006Technician Menu
2.2.2 Set powder
2. Set parameters
2.2.2.1 Powder doses
2.2.2.2 Doser setting
2.2.3 Selection status
2.2.4 Sel. <-> button
2.2.5 Check no. selec.
2.2.2 Setting the powders
2.2.2.1 Powder doses
The powder dose expressed in grams can be set for each
selection button, for each product that composes such selec-
tion.
2.2.2.2 Setting the doser units
This function is used for setting the flow rate of the single
doser units, expressed in g/s, to calculate the amount of
powder to be dispensed, for correct conversion of product
dose values.
2.2.3 Selection status
Each single selection button can either be enabled or disabled.
2.2.4 Button <--> Selection
This function permits the association of a selection number,
indicated in the selection dose table, to a button in the direct
selection keypad.
2.2.5 Checking the selection number
Verifying the selection number associated to a button.
To Next Page
Loading...
Need help?
General
