EasyManuals Logo

Nederman FlexPAK 1000 Setting Manual

Nederman FlexPAK 1000
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
FlexPAK 800/1000
11
EN
3.1.3 Running (Running mode)
The unit in Running mode. The pump motor is on and the unit generates a vacuum. The
FCV is closed. The current vacuum of the unit is shown on the display, for example, -20 kPa.
ESC OK
Running
kPA -20
DIRTm 00:00 s
OTTmr 00:00 h
Exhaust
Air Temp 60°C
DIRTm: The amount of me before the unit goes into Idling mode. The
default is 10 seconds. See also Secon ‘4.2.7 DIR_Time’.
OTTmr: If the Overme mer has been acvated, OTTmr shows the
elapsed me since the overme mer started.
The temperature of the exhaust air is displayed at the boom of the
display.
3.1.4 FlexPAK Idling (Idling mode)
The unit in Idling mode. The pump motor is on, there is no vacuum, and the FCV is open.
The unit goes into Idling mode when there has been no pilot signal for the me set in DIR_
Time, see Secon ‘4.2.7 DIR_Time’.
ESC OK
FlexPak
Hi Vacuum Unit
IDLING
Time To StandBy
05:33m
TimeToStandby: The amount of me unl the unit goes into Standby
mode. The default seng is 12 minutes. See Secon ‘4.2.4 SSR_Time’.
3.1.5 Filter Cleaning
The unit is cleaning its lter.
ESC OK
Filter
Cleanining
Cycles 1
Elapsed 0
Clean 00:00 s
Charge 00:00 s
Cycles: How many cleaning pulses will be carried out.
Elapsed: How many cleaning pulses are made.
Clean: Remaining me for cleaning pulse.
Charge: Remaining vacuum build me; the me unl cleaning pulse is
acvated.
3.1.6 Emptying preseparator
The me remaining unl the preseparator bin is to be emped.
ESC OK
EMPTYING
Preseparator
Bin 1 08:00s
Bin 2 06:00s
Bin 1: The me remaining to empty the preseparator as set in BinOpnTm.
Bin 2: The me remaining for preseparator 2 to be emped as set in
PresepTm.
3.1.7 Open Upper Slide Valve V12
The message appears when the TVFD Upper Solenoid Valve is expected to open. The mer
is set with TVFDO-Al, see Secon ‘4.2.39 MFDPS-Al’. If the mer elapses, the ‘TVFD Alarm!
Upper Slide Not Open is acvated. This message is only shown when TVFD advanced is
acvated.
ESC OK
Open Upper
Slide Valve
Remaing time
06:00s
Remaining Time: The remaining me for the valve to open before the
alarm is acvated.

Table of Contents

Other manuals for Nederman FlexPAK 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nederman FlexPAK 1000 and is the answer not in the manual?

Nederman FlexPAK 1000 Specifications

General IconGeneral
BrandNederman
ModelFlexPAK 1000
CategoryDust Collector
LanguageEnglish

Related product manuals