Nederman FlexPAK 1000 Setting Manual

FlexPAK 800/1000
21
EN
4.2 Parameter sengs
4.2.1 Adjust the me and date
ESC OK
Thu 10:45
2018-02-01
ESC OK
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
ESC OK
Stop >
Program >
Setup >
Network >
Diagnoscs >
ESC OK
Msg Config >
Start Screen >
Clock >
LCD >
Menu Language >
Switch to OP
ESC OK
Set Clock >
S/W me >
Sync >
Thu 10:45
2018-02-01
ESC OK
Set Clock
Do the following to adjust the me and date:
1. From the PLC status screen, press the down arrow to go to the date and me
screen.
2. Press ‘Escape’
ESC
to go to the main menu.
3. Pressthe down arrow to go to ‘Setup’. Press ‘OK’
OK
to conrm.
4. Pressthe down arrow to go to ‘Clock’. Press ‘OK’
OK
to conrm.
5. Pressthe down arrow to go to ‘Set Clock’. Press ‘OK’
OK
to conrm.
6. Use the le and right arrows to move to cursor to parameter value. Press ‘OK’
OK
to conrm.
7. Use the up or down arrows to set Time or Date. Press ‘OK’
OK
to conrm.
Weekday is automacally set by the date.
8. Press ‘Escape’
ESC
3 mes to go to the me screen.
9. Press the up arrow to exit.
NOTE! There are several other input menus on the same level as the date and me screen.
If pressing the down arrow
takes the PLC to one of those menus, use the le arrow
to get to the date and me screen.

Nederman FlexPAK 1000 Specifications

General

Brand	Nederman
Model	FlexPAK 1000
Category	Dust Collector
Language	English