Nederman FlexPAK 1000 Setting Manual

FlexPAK 800/1000EN
20
4 PLC sengs
The following PLC displays show the dierent sengs that can be congured for the unit.
4.1 Find a parameter and set its value
ESC OK
Thu 10:45
2018-02-01
ESC OK
Stop >
Program >
Setup >
Network >
Diagnoscs >
ESC OK
Set Parameter
Program Name
ESC OK
FlexPak
Hi Vacuum Unit
OFF
Time To Service
2000 hours
ESC OK
H-Meter 1/1
MI =2000h:0m
OT =0h:15m
MN =1999h:45
MN Ext =2000
ESC OK
H-Meter >
SSR_Time >
Cool_Tmr >
ClenCyl >
FItClean >
DIRTime Z
Do the following to nd a parameter and set its value:
1. From the PLC status screen, press the down arrow to go to the date and me
screen.
2. Press ‘Escape’
ESC
to go to the main menu.
3. Press the down arrow to go to ‘Program’. Press ‘OK’
OK
to conrm.
4. Select ‘Set Parameter’. Press ‘OK’
OK
to conrm.
5. Use the up or down arrows to nd the parameter. Press ‘OK’
OK
to conrm.
6. Use the le and right arrows to select a value.
7. Use the up or down arrows to set the value. Press ‘OK’
OK
to conrm.
8. Press ‘Escape’
ESC
to go to the main menu.
9. Press ‘Escape’
ESC
to go to go to the date and me screen.
10. Press the up arrow to exit.
NOTE! There are several other input menus on the same level as the date and me screen.
If pressing the down arrow
takes the PLC to one of those menus, use the le arrow
to get to the date and me screen.
NOTE! The blinking cursor shows the current value that can be changed.

Nederman FlexPAK 1000 Specifications

General

Brand	Nederman
Model	FlexPAK 1000
Category	Dust Collector
Language	English