Nederman FlexPAK 1000 Setting Manual

FlexPAK 800/1000
17
EN
3.3.8 Alarm! Control Filter Clogged
The control lter is clogged and needs to be cleaned. It generally indicates a problem with
the main lter, or the control lter has been used too long and needs to be replaced. This
alarm is acvated when CFDPS-Al has been acvated for 5 seconds. Press the green OK
buon
OK
to reset the alarm. See Secon ‘4.2.16 CFDPS-Al’.
ESC OK
Alarm!
Control Filter
Clogged
Th 15:01
Unit is Stopped
Reset OK 
3.3.9 TVFD Alarm! Upper Slide Not Closed
The TVFD Upper Solenoid Valve does not close while the dust bin is being emped. TVFDC-
Al has expired. It can be caused by the following:
• The upper slide valve has not been acvated as it should.
• Something can be stuck in the upper slide valve.
• The compressed air pressure hose has either been disconnected or the compressed
air pressure is too low.
This message is only shown when TVFD advanced is acvated.
ESC OK
TVFD Alarm!
Upper slide
not closed
Th 11:23
Unit is Stopped
Reset OK==>
3.3.10 TVFD Alarm! Upper Slide Not Open
The TVFD Upper Solenoid Valve does not open while the dust bin is being emped. TVFDO-
Al has expired. It can be caused by the following:
• The upper slide valve has not been acvated as it should.
• Something can be stuck in the upper slide valve.
• The compressed air pressure hose has either been disconnected or the compressed
air pressure is too low.
This message is only shown when TVFD advanced is acvated.
ESC OK
TVFD Alarm!
Upper slide
not open
Th 11:23
Unit is Stopped
Reset OK==>

Nederman FlexPAK 1000 Specifications

General

Brand	Nederman
Model	FlexPAK 1000
Category	Dust Collector
Language	English