EasyManuals Logo

Nederman FlexPAK 1000 Setting Manual

Nederman FlexPAK 1000
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
FlexPAK 800/1000
13
EN
3.1.12 Isolaon Damper Closing Duct
When the parameter (Sokey, DuctIsoDamp = On), FlexPak is congured to control a
damper that separates the lter from the factorys channel system. The message appears
before lter cleaning starts. The display shows the me delay set for opening the damper
aer lter cleaning.
ESC OK
Isolation Damper
Closing Duct
Delay Open Time
04:00s
RemaningTm 02:00s
3.1.13 Emptying bin AEB ap valve
When the system is congured for an AEB Flap Valve, the following message appears when
BIN emptying is performed. The message is displayed about Parameter → AEB-TVFD = On.
ESC OK
EMPTYING BIN
Open
AEB Flap Valve
Remaing Time
04:00s
3.1.14 Emptying bin TVFD simple
When the system is congured for a simple TVFD without the limit mode sensor, the
message below will be displayed when BIN emptying is performed. The message is
displayed about Parameter → AEB-TVFD = O.
ESC OK
EMPTYING BIN
Open Lower
Slide Valve
Remaing Time
02:00s
When the system is congured for an AEB Flap Valve, the following
message appears when BIN emptying is performed.
The message is displayed about Parameter → AEB-TVFD = On.
3.2 Warning messages
If a warning is acvated, there is a problem that needs to be corrected, but the unit
connues to work. If a warning message is displayed in the PLC display, the light in the
Standby/Running buon ashes one second on, one second o. This 1/1 on/o sequence
connues unl the problem is corrected.
There are two excepons to this rule, Secons ‘10.3.1 Time For service’ and
‘3.2.4 Bag Replacement Switch Acvated’.
3.2.1 Time For service
The me interval set in the ‘Service Interval Seng’ menu has expired. If this warning is
acvated, the light in the Standby/Running buon is lit one second and then again in 7
seconds. This 1/7 on/o sequence connues unl the warning is reset.
Reset the alarm by rst pung the unit into O mode. Restart the unit. In Standby mode,
press the manual lter cleaning buon for 10 seconds.
ESC OK
FlexPak
Hi Vacuum Unit
Time for
Service
Th 15:01
Reset OK
E
M
E
R
G
E
N
C
Y
S
T
O
P

Table of Contents

Other manuals for Nederman FlexPAK 1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nederman FlexPAK 1000 and is the answer not in the manual?

Nederman FlexPAK 1000 Specifications

General IconGeneral
BrandNederman
ModelFlexPAK 1000
CategoryDust Collector
LanguageEnglish

Related product manuals