INSTALLER SET
SYST. 07
Expert Setting Plus
Factory Setting Values
8 Nominal temperature difference for
pump speed control
From to
9 Unit temperature difference for pump
speed control
From to
10 Minimum pump speed ratio
From to
11 Tube collector temperature test duration
(if TUBE type collector)
From to
6HW&RQÀJ
Factory Setting Values
1 Collector Type
or
2 Cylinder temperature setpoint
From to
3 2nd Cylinder temperature setpoint
From to
4 R1 Output, R1 pump control, ON/OFF
mode (STD) bor speed variation mode
(RPM)
ou
5 Temperature difference to switch on the
solar heating
From to
6 Temperature difference to switch off the
solar heating
From to
7 R2 output to valve, Valve way in idle
state
or
66
SYSTEM 08: Solar system with 2 DHW cylinders (or 2-layer
cylinder), 3-way valve and Electric auxiliary heating