INSTALLER SET
SYST. 12
Expert Setting
Factory Setting Values
4 Maximum cylinder temperature (safety)
From to
5 Minimum pump-on duration
, or
Expert Setting Plus
Factory Setting Values
1 Length collector probe
2 Temperature difference zero adjustment
value
From to
3 Additional temperature difference zero
adjustment value
From to
4 T1 temperature zero adjustment value
From to
5 T2 temperature zero adjustment value
From to
6 T3 temperature zero adjustment value
From to
7 T4 temperature zero adjustment value
From to
8 Nominal temperature difference for
pump speed control
From to
9 Unit temperature difference for pump
speed control
From to
10 Minimum pump speed ratio
From to
11 Tube collector temperature test duration
(if TUBE type collector)
From to
80
To Next Page
Loading...