The Ness ECO8x control panel has a Temporary
Day Zone feature which allows easy and flexible
Day Zone selection and operation.
Temporary Day Zones operate in addition to
Permanent Day Zones which are usually setup
by the installer.
While remaining in normal operating mode,
the user can add and remove ‘Temporary Day
Zones’.
As an extra feature, the user can easily enable
or disable Day Mode, (which includes both
Temporary and Permanent Day Zones).
Day Zones can be programmed by your installer
to beep the keypad, or briefly sound the siren/s
or flash the strobe light.
TYPICAL APPLICATIONS
Day Zones are useful for a variety of applications
such as a shop door beeper, triggered by a reed
switch on the door.
For example, in a shop you could enable Day
Mode to alert you when a customer enters the
front door.
You can also enable additional Temporary Day
Zones to monitor switches on, for example, the
rear door or the fridge doors.
COMMANDS
(Accessed from normal operating mode).
ENTER SELECTION MODE.
Press followed by when in
operating mode to enter Temporary Day
Zone selection mode.
ZONE SELECTION.
[Zone no.]+
To select or deselect zones to be Temporary
Day Zones. The selected zones are indicated
by the corresponding zone number.
Permanent Day Zones, (installer option
P53E), are not displayed in selection mode.
Permanent Day Zones can be selected as
Temporary Day Zones but this has no effect
as those zones are already day zones.
EXIT SELECTION MODE.
Press to saves changes and return to
normal operating mode.
ENABLE DAY MODE.
Press + to enable/disable Day
Mode.
When Day Mode is enabled, any unsealed
day zone will sound the programmed
output for 2 seconds. When Day Mode is
disabled, an unsealed day zone will simply
be indicated on the keypad as an unsealed
zone.
The
HOME light flashes continuously
when Day Mode is enabled
TeMpOrAry dAy ZONes
To Next Page
Loading...
