AUdIbLe MONITOrINg
As a lower security alternative to central station
monitoring, the panel can be programmed to
send audible messages to a fixed or mobile
phone.
The telephone number/s to call need to be
programmed by your installer.
When triggered by an alarm, the dialler will
call the programmed telephone number/s and
output the audible message for 45 seconds or
until it is acknowledged.
The audible message consists of the warning
words ALARM, ALARM, ALARM followed by the
alarm message sent as a series of beeps
The Ness ECO8x control panel has an on-board
digital dialler which can send detailed alarm
messages to a Central Monitoring Station.
The digital messages can include information
about the zone or zones which caused the alarm,
tamper alarms, low battery or mains failure
reports, and it can also (by user number) identify
the users who arm and disarm the system.
MONITOrINg
ACKNOWLEDGING THE ALARM
The person receiving the call can then
acknowledge the alarm by pressing the key
on their telephone. Press the key for at least
2 seconds after the alarm beeps.
If the alarm is not acknowledged, the LINE light
on the keypad will flash continuously until the
panel is next armed.
Central station monitoring is highly recommended
and is the most effective method of monitoring
your alarm system.
For further information about 24 hour monitoring,
contact your installer or Ness Security
Products.
or...
CeNTrAL sTATION MONITOrINg
To Next Page
Loading...
