NESS ECO8x CONTROL PANEL – USER'S MANUAL
19
prOgrAMMINg
Programming your Ness ECO8x is a simple
process using the keypad.
To enter program mode you need to know
your Master Code, which is user code
number 1, (see the table on the next page).
If you forget your Master Code it can be reset
by your installer.
USER CODES
The ECO8x panel has 15 user codes which
can be operated by keypad code (3-6 digit
PIN) or by optional radio key.
To add, change or delete a keypad code,
follow the steps on page 21.
To add or delete radio keys, ask your
installer.
The panel is supplied with the Master Code
pre-programmed as 123. You should re-
program this code with a new code of your
own choice.
TIMERS
You can also re-program the Entry Delay Time
and Exit Delay Time if you need more or less
time to exit and enter the premises.
MONITORING
Your installer can program the ECO8x to
report alarms via the onboard dialler to either
your mobile phone or to a central monitoring
station.
Ask your installer for details.
NOTE 1. The panel will automatically exit Program
Mode if the keypad is inactive for 4 minutes.
NOTE 2. The Panic alarm is be disabled while in
Program Mode.
TO ENTER USER PROGRAM MODE
From the disarmed state.
Press +[Master Code]+
The factory default Master Code is 123.
The
button will light up in red while in User
Program Mode.
TO EXIT PROGRAM MODE
Press +
The button light will turn off.
To Next Page
Loading...
