Ness ECO8x User Manual

NESS ECO8x CONTROL PANEL – USER'S MANUAL
10
OperATION
The control panel must be armed in order to
detect intruders.
Before arming, all zones should be Sealed by
making sure there is no movement in rooms
protected by motion detectors. Doors or
windows protected by reed switches should
be closed.
The panel cannot be armed if in Program,
Home, Memory or Exclude modes or if it is in
alarm. (User codes that are programmed as Arm
Only* codes can arm the panel either from the
disarmed state or from Home Mode.
A keypad is supplied with the panel. Operation
by Radio keys is optional.
10
10 beeps when you arm means
Mains Power is turned off or the backup battery
is low.
One long beep when you arm could
mean the panel is already armed or the keypad
code is wrong, (if not using Shortcut Arming).
Siren Warning:
At the end of the exit time, all zones should be
Sealed. If any are Unsealed, the siren will sound
for 2 seconds to indicate that those zones have
been automatically excluded. You should disarm
the panel, check the premises and then arm
again. Continual warnings could mean there is
a problem with a detection device - that zone
may have to be manually excluded.
If a zone is Unsealed at the end of exit time and
the auto-exclude option is disabled, the siren
will sound for the duration of siren time, (default
is 5 minutes).
* This is an in staller programming function.
To ARM the panel
by KEYPAD by RADIO KEY
When the READY light is on, you can arm by...
Press
+
(If the Arming ShOrtcut is enabled).
Press the ON button once.
The strobe light will flash briefly.
If required, your installer can
program the external siren to chirp
once when disarming by radio key.
(If Home Arming by Radio Key is
enabled, the chirp will be delayed by
5 seconds).
Or press +[User Code]+
Or press [User Code] +
(If cOde Only Arming has been enabled by your
installer).
The A
rmed buttOn will light up. Leave the premises within the Exit Delay Time. 3 beeps will
sound at the end of Exit Delay Time.

Ness ECO8x Specifications

Power

plug pack voltage	240 V AC
plug pack output voltage	17 V AC
plug pack output current	1.4 A
power supply voltage	13.8 V DC
power supply current	800 mA

Battery

battery voltage	12 V
battery capacity	7.0 Ah
battery charging current	350 mA

Inputs and Outputs

zone inputs	8
end of line resistor	2200 Ohms
maximum keypads	3

Weight and Dimensions

box width	235 mm
box height	300 mm
box depth	90 mm