64
User Manual
Alarm output(1~2);Video area mask(No mask);Preset poll(Closed);Pre-record time(10s);Delay record time(30s).
4.9.5 Password Reset
When you forget the system password or the admin’s password, the factory’s default setting can be retrieved by the following operation.
The operations are as follows:
1.Shut off the machine and cut off the power supply.
2.Unload the cover screw, and remove the case lid from the machine.
3.Find J1, it's on top right of the SCM which is beset on the back of the front panel.
4.Jump the thread piece to put the legs 1, 2(next to the resistance R13) of J1 to the status of short circuit.(the thread piece is put on the legs 2, 3 when
leave factory)
5.Connect the power supply, and start the machine. You can hear buzzer sounds, and it indicates that the passwords have been set to the default value
at the moment.
6.Shut off the machine again, and cut off the machine power supply.
7.Pull out the jumping thread piece, and let the legs 2, 3 of J1 to the status of short circuit.
To Next Page
Loading...