Doc. Name: NMC-PRO
Installation Manual Revision: 2 Page: 28
Crop Management Technologies
# Parameter Explanation Unit/Range Default
10.
Vent Calibration
Curve
A four point table used to define the vent
physical positions and measured position
voltage.
0 – 100%
(position)
0 – 5000 mV
0
0
11.
Wind vent
position during
Frost Event
The position of the vent during an
Emergency Frost event
NOTE: Done By Factory Technician – cannot
be configured by the Technician
0-100% 0
12.
Lee vent
position during
Frost Event
The position of the vent during an
Emergency Frost event
NOTE: Done By Factory Technician – cannot
be configured by the Technician
0-100% 0
To Next Page
Loading...
