Netafim NMC PRO CLIMATE - System Installation and Configuration; Firmware Upgrade; Accessing the Application; Running the Application

NMC-PRO
INSTALLATION GUIDE
Doc. Name: NMC-PRO
׀
Installation Manual Revision: 2 Page: 18
Crop Management Technologies
System Installation and Configuration
FIRMWARE UPGRADE
The Bootloader application enables installing or updating the system firmware. The
application is menu based and simple to use and enables updating the firmware from an SD
card or a PC.
Note: If you plan on updating the firmware from an SD card, verify that the card is in place
before starting.
Accessing the Application
1. Press and hold the Left and Down arrow keys.
2. Turn on the unit.
In the screen that appears, enter the password: 38845.
Note: If you enter the wrong password, an error message appears and the program goes to
the Main Screen. Repeat the process.
3. Press Enter. The screen below appears.
Running the Application
Notes: Pressing Exit or ESC takes you to the previous menu.
1. Select the SD Card or PC.
Note: Hardware Test is used for quality control only.
 If you choose PC (Serial), a “Flash Programmer” application updates the firmware.
Follow the online instructions.
SELECT SOURCE
PC (Serial)