Netafim NMC PRO CLIMATE - Screen (Menu 8.2.2)

NMC-PRO
INSTALLATION GUIDE
Doc. Name: NMC-PRO
׀
Installation Manual Revision: 2 Page: 29
Crop Management Technologies
Screen (Menu 8.2.2)
# Parameter Explanation Unit/Range Default
1. Screen number
Screen number referring to Installation 
Digital Output
1-2
2. Energy saving %
Define the energy saving percent as defined
by the screen manufacturer. In cases where
there are two screens, one above another,
the energy saving percent will be the sum of
the two screens.
0-100% 20%
3.
Radiation
Transferability
The transferability of light as defined by the
screen manufacturer
0-100% 70%
4. Snow Protection Define if to operate during snow protection. Yes/No Yes
5.
Step Size per
stage during a
snow event
Define the size of each step of the screen
during a snow event
0-100% 10%
6.
Delay between
steps during a
snow event
Define the delay between each step during a
snow event
mm:ss 00:00
7.
Air temperature
set point to
indicate snow
Define the air temperature that should be
measured in order to indicate a snow event.
This will protect against faulty indications of
the snow detector.
-50
o
C to
+50
o
C
3
o
C
8.
Spreading Run
Time
Define the time that the screen takes from
fully CLOSED to fully OPEN
mm:ss 02:00
9.
Collecting Run
Time
Define the time that the screen takes from
fully OPEN to fully CLOSED
mm:ss 02:00
8.2.2. Screen cfg.
Zone 1
19/01/09 16:21
1. Screen #
2. Energy saving %
3. Rad transfer %
4. Use snow protection
5. Step size per stage %
6. Delay between step mm:ss
7. Temp for active snow°C
8. Spread run time mm:ss
9. Collect run time mm:ss
10. Run delay mm:ss
11. Extra run time mm:ss
12. Calib curve mv/Pos %
1
20
70
YES
10
00:05
3.0
02:00
02:00
00:01
00:20
1
20
70
YES
10
00:05
3.0
02:00
02:00
00:01
00:20