Security Gateway Manual XG-7100
At this point SFP+ port ix0 is now configured as the WAN interface. The LAN interface is still configured the same as
the default. Next, the switch will need to be updated so that ETH1 (previously WAN) acts the same as ETH2-8. This
will be done from the GUI.
From the GUI, navigate to the Switch VLAN configuration under Interfaces > Switches, VLANs tab:
VLAN 4090 is no longer needed since WAN is now dedicated to ix0. Either select on the row containing 4090
to delete this entry, or click to remove port 1 as a member:
© Copyright 2024 Rubicon Communications LLC 32
To Next Page
Loading...
