Factory Settings
You can return the cable modem router and satellite to its factory settings. Use the end of a paper clip or a
similar object to press and hold the Reset button on the back of the cable modem router or satellite for at
least seven seconds.The cable modem router or satellite resets, and returns to the factory settings.
Factory Settings for Orbi Cable Modem Router
The following table shows the factory default settings for the cable modem router.
Table 5. Factory default settings for the cable modem router
Default SettingFeature
orbilogin.comUser login URLRouter
login
adminUser name (case-sensitive)
passwordLogin password (case-sensitive)
Use default hardware addressWAN MAC addressInternet
connection
1500WAN MTU size
AutoSensingPort speed
192.168.1.1LAN IPLocal
network
(LAN)
255.255.255.0Subnet mask
EnabledDHCP server
192.168.1.2 to 192.168.1.254DHCP range
192.168.1.2DHCP starting IP address
192.168.1.254DHCP ending IP address
DisabledDMZ
GMT for WW except NA and GR, GMT+1
for GR, GMT-8 for NA
Time zone
DisabledTime zone adjusted for daylight saving
time
DisabledSNMP
Disabled (except traffic on port 80, the
HTTP port)
Inbound (communications coming in from
the Internet)
Firewall
Enabled (all)Outbound (communications going out to
the Internet)
DisabledSource MAC filtering
Supplemental Information
97
Orbi WiFi System
To Next Page
Loading...
Need help?
General
