Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual
A-2 Technical Specifications
v1.0, July 2008
Default Configuration
You can use the Wireless On/Off and WPS buttons located on the side panel of your router to reset
all settings to their factory defaults. This is called a hard reset. To perform a hard reset, push and
hold the Wireless On/Off and WPS buttons simultaneously for 6 seconds. Your router will return
to the factory configuration settings shown in the following table.
Interface Specifications
LAN: 10BASE-T or 100BASE-Tx, RJ-45
WAN: ADSL, Dual RJ-11, pins 2 and 3
T1.413, G.DMT, G.Lite
ITU Annex A or B
ITU G.992.5 (ADSL2+)
Feature Default Behavior
Router Login
User login URL http://www.routerlongin.com
User name (case-sensitive) admin
Login password (case-sensitive) password
Internet Connection
WAN MAC address Use default address
WAN MTU size 1500
Port speed Autosensing
Local Network (LAN)
Lan IP 192.168.0.1
Subnet mask 255.255.255.0
RIP direction None
RIP version Disabled
RIP authentication None
DHCP server Enabled
DHCP starting IP address 192.168.0.2
Specification Description
To Next Page
Loading...
Need help?
General
