Wireless-N ADSL2+ Modem Router DGN2000 Reference Manual
Connecting Your Router to the Internet 1-11
v1.0, July 2008
ADSL Settings
The default ADSL settings of your modem router work fine for most ISPs. However, some ISPs
use a specific multiplexing method and virtual circuit number for the virtual path identifier (VPI)
and virtual channel identifier (VCI).
If your ISP provided you with a multiplexing method or VPI/VCI number, then enter the setting:
1. From the main menu, select ADSL Settings.The ADSL Settings screen displays.
2. In the Multiplexing Method drop-down list, select LLC-based or VC-based.
3. For the VPI, type a number between 0 and 255. The default is 8.
4. For the VCI, type a number between 32 and 65535. The default is 35.
5. Click Apply.
Note: For information about how to install ADSL filters, see the Wireless-N ADSL2+
Modem Router DGN2000 Setup Manual.
Note: You must use the Setup Wizard to select the correct country for the default ADSL
settings to work.
Figure 1-5
To Next Page
Loading...
Need help?
General
